CATEGORIES
Contact Us

Tel: +86-755-33855915

Fax: +86-755-33855919

Mail: sales@stcforcable.com

Add: No.7 Xiuhua Road, Third Industrial Zone, Tangxiayong Community, Songgang Town, Baoan District, Shenzhen, Guangdong, China (Mainland)

Post: 518105

Home > Exhibition > Content

How to choose a good usb charging and data cable for your mobile phone ?

Shenzhen STC Cable Manufacturer | Updated: Jun 27, 2017
Source:

Most of us will have a few USB data and charging cables for our mobile phone, i.e. one at home, one in office, one carrying together with our laptop, etc.

Do you encounter the problem of slow charging, or worst still, unable to charge with the additional USB cable that you bought? Perhaps you can find the solution after reading this.
First of all, although most of the USB cables look alike from their external appearance, they might be different inside the cable, and probably that is the ready why certain USB cable unable to charge your mobile phone, certain can charge but at a very slow rate, certain just work as fine as the original USB cable that come with your phone, and certain even can charge faster than the original cable.
There are 5 wires inside the USB 1 and USB 2 cables, and there are more inside USB 3.0 cable. Since most of the mobile phones nowadays are using USB 2.0 connector, so USB 3.0 is out of our topic here.


he 5 wires are:                                         
2x 28 AWG data lines                                              AAEAAQAAAAAAAAt_AAAAJGZlOWIwOTJkLThkY2QtNGQ4Mi1iNDhkLTEwZWQ1MGYyOWZiZg.png     2x 20-28 AWG power conductors      

 1x drain wire

and those 5 wires are connected to the 5 pins in your micro-USB connector.



In fact, there are two kinds of USB cable: fully-rated and sub-channel. The main difference between them is that fully-rated cable can be used for typical peripherals operating at the rate of 480 Mbps (high speed) signalling, while the sub-channel one at the rate of 1.5 Mbps (standard speed) signalling. The construction inside the cable fully-rated and sub-channel cable is different:

You can probably see some printed codes on the good quality USB cable, including something like this: "28AWG/2C and 24AWG/2C" or "28AWG/1P + 24AWG/2C".
The first code is normally the specification of the data signal pair, which is normally 28AWG. "2C" means 2 conductors, and "1P" or "1Pr" means 1 pair. "2C" and "1P" are basically the same.

Feedback
Shenzhen STC Cable Manufacturer
Copyright © Shenzhen STC Cable Manufacturer All rights reserved.